Installing Hanger Ball/Downrod Assembly - Emerson ASHLAND CF717BS01 El Manual Del Propietario

Your ceiling fan is designed to be installed either in the standard manner, or in the
close-to-the-ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend the
fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover installs
directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the standard
method. In no case should the fan blades be lower than seven feet above the floor. Depending on your desired
mounting method, proceed to "3. INSTALLING HANGER BALL/DOWNROD ASSEMBLY" for standard
mounting, or to
close-to-the-ceiling mounting.

3. Installing Hanger Ball/Downrod Assembly

3.1
Remove the hanger ball by loosening the setscrew in the
hanger ball until the ball falls freely down the downrod
(Figure 1).
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for
reinstallation in Step 3.6.
3.2
Separate, untwist and unkink the three 80" motor leads.
Route the motor lead wires through the downrod.
Loosen the two setscrews preinstalled on the motor
coupling.
Align the clevis pin holes in the downrod with the holes in
the motor coupling. Install the clevis pin and secure with
the hairpin clip (Figure 2).
The clevis pin must go through the holes in the motor
coupling and the holes in the downrod. Be sure to push the
straight leg of the hairpin clip through the hole near the end
of the clevis pin until the curved portion of the hairpin clip
snaps around the clevis pin.
The hairpin clip must be properly installed to prevent the
clevis pin from working loose. Pull on the downrod to make
sure the clevis pin is properly installed.
IMPORTANT
"4. INSTALLING CEILING
(For Standard Mounting)
COVER ON FAN
Figure 1
SETSCREW(2)
SETSCREW
CLEVIS PIN
CLEVIS PIN
Figure 2
Please contact 1-800-654-3545 for further assistance
5
MOTOR HOUSING"
PIN
HANGER BALL
SETSCREW
DOWNROD
DOWNROD
DOWNROD
HAIRPIN
HAIRPIN
CLIP
CLIP
MOTOR
COUPLING
MOTOR
COUPLING
emersonfans.com
ETL Model No.: CF717-1
for