Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 23

19
idrive
NOTE: See idrive
Tools Needed:
instructions and owner's manual for
idrive
parts.
®
IMPORTANT: RIGHT AND LEFT HAND
IS ALWAYS DETERMINED FROM INSIDE
THE GARAGE LOOKING OUT.
With the TorqueMaster
the floor (inside garage) in front of the
door with the labeled end to the left.
Look into the opener's left side to
ensure the left hand bearing and the
internal (black) sleeve are aligned with
the TorqueMaster
IMPORTANT: HOLD OPENER BY THE
MAIN BODY. DO NOT HOLD BY THE
MOTOR.
NOTE: Opener will not slide over a
torque tube label. Attempting to slide
opener over the left end of the
TorqueMaster
the internal electronics.
Once aligned, slide the opener onto the
right hand end of the TorqueMaster
spring tube. As the right end of the
TorqueMaster
internal (black) sleeve, rotate the
opener back and forth slightly to help
aid alignment.
Continue sliding the opener onto the
TorqueMaster
right hand bearing with the
TorqueMaster
the opener completely onto the
TorqueMaster
TorqueMaster
opener right hand bearing.
NOTE: Do not force the opener onto the
TorqueMaster
misalignment occurs.
Continue sliding the opener to the
center of the TorqueMaster
tube.
Plug the motor power cord into the
opener.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Installation
®
main installation
®
spring tube on
®
spring tube profile.
®
spring tube can damage
®
®
spring tube enters the
®
spring tube. Align the
®
spring tube and slide
®
spring tube until the
®
® spring tube exits the
spring tube if
®
spring
®
LEFT HAND SIDE
TORQUEMASTER SPRING TUBE
®
AND BEARING PROFILES ALIGNED
RIGHT HAND END
OF TORQUEMASTER
®
SPRING TUBE
MOTOR
RIGHT HAND SIDE
TORQUEMASTER
®
SPRING TUBE AND
BEARING PROFILES
ALIGNED
PLUG-IN MOTOR
POWER CORD
23