Instruments Operation; Pneumatic Handpiece Couplings; Optical Fiber Handpiece (Optional); Scaler (Optional) - Olsen SPRINT Manual De Operaciones

6.1 - Pneumatic Handpiece Couplings

Before starting the operation connect the handpiece (1) to
the coupling by attaching it to the coupling ring (2), ensuring that
it is properly connected and that there is no leakage of air or water.
To activate the rotation: press the propulsion/activation
pedal (5). The higher the pressure applied to the pedal, the more
speed in the handpiece until reaching the pressure limits of the
equipment.
To adjust the spray: turn the adjusting ring (4) until the desired volume of water. To
adjust the maximum flow of water, bring the spray adjustment indicators (3) closer to each
other. To decrease the flow of water, rotate the ring so it distances one indicator from the other.
The completely opposite points indicate the minimum water regulation for the spray.
Note: spray adjustment is not available for the air terminal without refrigeration.

6.2 - Optical Fiber Handpiece (Optional)

Before starting the operation connect the optical fiber
handpiece to the coupling by attaching it to the coupling
ring (1), ensuring that it is properly connected and there is no
leakage of air or water.
To activate
propulsion/activation pedal (2). The higher the pressure
applied to the pedal, the more speed in the handpiece until
reaching the pressure limits of the equipment.
To turn the coupling's light On/Off: use the On/Off key (3)
on the left side of the working table (section 5.4).
To adjust the spray: use the optical fiber water control
knob (4) on the instruments' control panel.
6.3 – Scaler (Optional)

6.3.1 - Standard Scaler

To start the use of the scaler it is necessary to first
install the tip that will be used, according to the instructions
in section 6.2.2.
To activate the scaler: it is necessary to remove the
scaler from the support and press the propulsion/activation
pedal (6).
Observe the settings for the scaler in section 6.2.3.

6.3.2 - Scaler with LED Light (Optional)

For the use of the scaler, it is necessary to connect the
transducer (1) to the coupling (3) and install the tip on the
transducer.
To attach the transducer (1) to the coupling: align the
adjustment indicators (2) of the two parts and carefully insert them.

6 - Instruments Operation

the rotation: press the
15