Eletric Micromotor (Opcional); Adjustments Of The Electric Micromotor; Curing Light (Optional); 3-Way Syringe - Olsen SPRINT Manual De Operaciones

6.5 Eletric Micromotor (Opcional)

Before starting the operation, connect the handpiece to the
electric micromotor (2).
To activate the rotation: press the progressive/actuation
pedal (1).

6.5.1 - Adjustments of the Electric Micromotor

To adjust the speed: turn the control knob (3) until the
desired speed is reached.
To change the direction of rotation: use the direction of
rotation control (4).
− FWD: clockwise;
− OFF: off;
− REV: counterclockwise.

6.6 - Curing Light (Optional)

Before starting the curing light use, install the
tip (1) and the light hood (2).
To install the tip: first, attach the light hood (2)
to the tip and then attach it to the curing light unit (3).
The tip must be pushed all the way to the fitting end.
To activate/deactivate the curing light: press the On/Off button (5) twice. The
green LED (4) indicates that the curing light is operating. The curing light unit will run
for 20 seconds and will turn off automatically.
To toggle the operating mode: each tap on the selection button (9) switches
the operation mode. Press the selection button (9) until the orange LED indicates the
desired mode.
The curing light operates in the following modes:
− Continuous (6): turns on the maximum power for 20 seconds;
− Ramp (7): turns on the minimum power, gradually increasing. In 5 seconds
reaches its maximum power until the cycle of 20 seconds is finished;
− Pulse (8): the device blinking for 20 seconds.

6.7 - 3-Way Syringe

Before beginning the use of the 3-way syringe (5), connect the syringe
tip (3) by pressing the locking ring (4) into the correct fit.
To emit air jet: press the air button (1).
To emit water jet: press the water button (2).
To emit spray jet: press simultaneously the air and water
buttons (1 and 2).
18