Completing The Installation - Gigaset C530 IP Manual Del Usuario

Gigaset C530 IP / LUG - USA en / A31008-XXXXX-XXXX-X-XX / starting.fm / 25.03.2015
Getting started
e.
Instead of a connection, you can also select Sel. at each call. Each time you make a call, you can
then select the connection you wish to use on this handset.
If other handsets are already registered to the base, you are requested to assign send and receive
connections for the handsets. The following is shown in the display:
Assign connections to handset ?
¤
Perform the steps a. to e. for each registered handset.
After successfully configuring the settings, you will briefly see the display Connection
assignment complete.

Completing the installation

The handset then returns to idle status (an example of the display in idle status):
Displays
u
Reception between the base and handset:
- good to poor:
- no reception:
Colour green: Maximum Range deactivated.
u
Battery charge status:
{
-
{
-
y
-
y
-
y
-
xy xy x{ x{
-
u
INT 1: Internal name of the handset
22
INT 1
Connection for
outgoing calls:
< IP 1 >
Save
Back
Ð i Ñ Ò
¼
(red)
White: charged over 66%
White: charged between 34% and 66%
White: charged between 11% and 33%
Red: charged below 11%
Flashes red: Battery almost empty (less than ten minutes of talktime)
If the handset is to make calls via a different
connection/phone number:
¤
Press right on the control key
often as required until the desired
connection is displayed (in example IP1).
¤
Press the display key Save to save the
settings.
White: Battery is charging
v
as
i
V
07:15
14 Oct
INT 1
Calls