Luminance Brands Kathy Ireland Home ZEKE CF444BQ00 El Manual Del Propietario página 24

8. Wall Control Installation
8.5
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan Wall Control into the Wall Box .
Before installing the Second Wall Control, place the
Wall Control in "OFF" mode by pushing "ON/OFF"
) to the "OFF" ( O ) position .
Switch (
Install the Second Wall Control (purchased separately)
into the Wall Box containing the "LOAD" Wire .
Connect the Second Wall Control Black Wire labeled
"TO POWER SUPPLY" to the Traveler Wire(s) already
connected to the Black Wire (in the other wall box) .
Secure with Wire Connectors, supplied (Figure 36) .
Connect Second Wall Control Black Wire labeled
"TO FAN" to the "LOAD" (Black) Wire and secure with
Wire Connector, supplied (Figure 36) .
Connect the Second Wall Control Green Ground
Wire to the Supply Ground Conductor (this may be
a bare wire or wire with Green Colored insulation) .
Securely connect Wires with Wire Connector, supplied
(Figure 36) .
Screw the Second Wall Control onto the Wall Box using
the supplied Screws . Leave the Wall Control in "OFF"
mode until Fan installation is completed .
NOTE: Retrofit 3-way installations are likely to
include two traveler wires between the two wall
boxes. In new construction, only one traveler wire Is
required (See Figure 36).
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
All Wall Controls are supplied with a White, Ivory, and
Almond color Switch Covers . Choose the finish that
best suits your needs and snap the Covers onto the
Wall Controls (Figure 36) .
Install Decorative Wall Plates using the two Screws
provided with each Wall Plate . Leave the Wall Control
in "OFF" mode until Fan installation is completed
(Figure 36) .
(Continued)
STANDARD WIRING FOR EXISTING
3-WAY CONTROLS
HOT
BLK
GND
3-WAY WIRING DIAGRAM: RETROFIT
ALL WALL CONTROLS
SCREWS (2)
Figure 36
24
EXISTING
WALL CONTROL
GND
TRAVELER WIRES
FAN/LIGHT WALL
SCREWS (2)
CONTROL
.... ....
OFF
OFF OFF
ON
ON ON
WALL BOX
SWITCH COVER
DECORATIVE WALL PLATE
ETL Model No.: CF444
LOAD