ICS 680ES Manual De Mantenimiento página 54

15. IGNITION COIL 680ES SERVICE MANUAL
15.5
Install ignition coil.
A. Place ignition coil shim (0.012")
B. Set ignition coil in place.
C. Install ignition coil screws, wave
washers, and plain washers with Loctite
®
242.
D. Holding shim, rotate flywheel magnet
around to coil.
E. Torque ignition coil screws to 26 in-
lbs.(3 Nm).
F. Remove shim, rotate flywheel to check
clearance.
15.6
Install flywheel shroud.
15.7
Route ignition stop switch wire through
crankcase into carburetor chamber.
15.8
Complete ignition wire routing.
54
© 2020 ICS- Blount Inc Specifications and pricing are subject to change without notice. P/N 598000 REV01162020