Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Insert visor into window channel, front flange first. Front
and rear flanges insert between the rubber trim and
the mirror cap / door frame. Top flange slides into the
window channel.
3
4 Piece Set
Install the rear visors using the same preparation and installation methods as the front visor.
Note that the rear flange adheres to the outside of the window post, and the front flange inserts
5
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost
pride in our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your
product is top quality in terms of fit, durability, finish and ease of installation.
™
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
between the rubber & window frame.
Repeat steps 1 thru 5 for passenger side
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
Remove tape liner by pulling on the free ends. Raise
window slowly and leave up for 24 hours to secure visor
4
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
to window channel.
Publicidad
