Using The Valve Balloon; Using The Tube Kit - STORZ & BICKEL HYBRID Volcano Modo De Empleo

5 . FA C T O R S I N F L U E N C I N G VA P O R I Z AT I O N
Since the plant ingredients are released
in a gentle manner, the vaporization
cycle may be repeated with the same
contents in the Filling Chamber. De-
pending on the four factors described
above, the load of the Filling Chamber
may be reused multiple times until the
aromas and fragrances are released
completely. Before a new vaporization
process, the contents of the Filling
Chamber can be removed and ground-
ed again to increase the surface area
of the starting material. An increased
temperature would activate more va-
por as well, but has a negative effect
on the taste. If no more vapors form at
maximum temperature, the vaporiza-
tion material is completely used up and
must be replaced with fresh material.
However, for the best aroma results it
is advisable to replace the vaporization
material before this point.

5.1. Using the Valve Balloon

When using the Valve Balloon, it is
important to observe the formation
of steam in it. A fine, white vapor feels
very comfortable when inhaled. As the
vapor gets denser the taste can get too
strong.
A very high intensity (density) of the va-
por can lead to irritation of the respira-
tory passages from the concentration
of the aromas and fragrances. In this
case, the temperature should be low-
erd, so that the intensity of the vapors
is reduced.
Watch vapor density
It is not necessary to fill the Valve Bal-
loon completely. It is often sufficient to
fill only half or even less than half of the
Valve Balloon in order to achieve the
desired results.
The Valve Balloon is not suitable for
storing vapors over a long period be-
cause the vapors condense on the
Valve Balloon Jacket over time (a few
hours). Only fill the amount you want to
inhale within 10 minutes.

5.2. Using the Tube Kit

The VOLCANO HYBRID can also be
used with the enclosed Tube Kit for
direct inhalation. Further details on us-
ing the Tube Kit are described in Chap-
ter 7.7. "Tube Kit", page 86.
68
ok