Temperature Setting - STORZ & BICKEL HYBRID Volcano Modo De Empleo

7. O P E R AT I N G T H E V O L C A N O H Y B R I D

7.3. Temperature Setting

Bluetooth® Display
Mains Operation
Display
Touch Button
Temperature
Minus
Touch Button
Heater (HEAT)
Briefly pressing the touch button Tem-
perature Plus or Minus changes the
setpoint values in 1 degree steps in the
corresponding direction. By continu-
ously pressing the touch button Tem-
perature Plus or Minus, the setpoint
values start to run continuously in the
corresponding direction. When the
touch buttons Temperature Plus and
Minus are pressed simultaneously, the
display changes from degrees Celsius
to degrees Fahrenheit and vice versa.
If the actual value is higher
than the set value, you can
speed up the cool off process
by switching on the pump.
The automatic switch-off is
preset to 30 minutes, which
can be individually adjusted
with the help of the app.
Pump Display
The display is dimmed down to 30% in
standby mode; dimming down to 10%
can be set using the app.
Whilst the heating still has significant
residual heat, this actual temperature
is displayed by default until it falls be-
low a value of +40°C (+104°F). The
residual heat display can be switched
off via the app, in this case the actual
temperature display goes blank as
soon as the heating is switched off.
The display will then go out and the
mains supply indicator, which then ap-
pears on the display, indicates that the
Hot Air Generator is connected to the
mains supply.
Pack and store the device
only after it has cooled down
completely.
76
Actual Temperature
Display (orange)
Touch Button
Temperature Plus
Touch Button
Pump (AIR)
Set Temperature
Display (white)