STORZ & BICKEL HYBRID Volcano Modo De Empleo página 83

7. O P E R AT I N G T H E V O L C A N O H Y B R I D
loss of vapor. It is important to observe
the vapor density in the Valve Balloon
(see Chapter 5. "Factors influencing
Vaporization", page 67).
ok
Watch vapor density
When the Valve Balloon is filled, switch
off the pump by tapping the touch
button pump (AIR) again - and remove
the Balloon together with the Filling
Chamber. To do this, grasp the Filling
Chamber Cap by the rotating knobs
and unscrew counterclockwise.
Remove Valve Balloon with Filling Chamber
Caution! Hot surface!
Do not touch any compo-
nents of the Filling Chamber
(except at the textured grip)
until they have cooled down
after the Valve Balloon has
been filled.
Do not leave the Filling Chamber on the
hot air outlet of the VOLCANO HYBRID
- except for filling the Valve Balloon - as
long as its heater is switched on.
81