Johnson JTP9C Manual De Usuario página 63

REMOTE CONTROL MANUAL
●
Water is removed from the air and collected in the tank.
●
When the tank is full, the appliance shuts down and
the unit display. The tank cap must be extracted and emptied. Run off all water left into
a basin. When all the water has been drained, put the cap back in place.
●
When the tank has been emptied, the appliance starts up again.
NOTE:
- When operating in very cold rooms, the appliance defreezes automatically,
momentarily interrupting normal operation.
this operation, it is normal for the noise made by the appliance to change.
- In this mode, you may have to wait for a few minutes before the appliance starts
giving out hot air.
- In this mode, the fan may operate for short periods even though the set temperature
has already been reached.
FAN mode
When using the appliance in this mode, the air hose does not need to be attached.
●
Press the
button until the "Fan" symbol appears on the unit panel .
●
Select the required fan speed by pressing the
Three speed settings are available: High/Med/Low.
DRY mode
Ideal to reduce room humidity (spring and autumn, damp rooms rainy periods, etc).
In dry mode, the appliance should be installed in the same way as the cool mode, with
the air exhaust hose attached to enable moist/humid air to be vented outside.
To set this mode Fan correctly:
● Press the button a number of times until the "
panel.
● In this mode, fan speed is selected automatically by the appliance and can not be
set manually.
V.1
" " (full tank) appears on
" " appears on the unit display. During
button.
" symbol appears on the unit
24