Getting Started; General Functions; Status Lights; Audio Sources And Priorities - SCHUBERTH SRC SYSTEM PRO Guía De Usario

5. GETTING STARTED

5.1 GENERAL FUNCTIONS

s
Press for 2 seconds
Power ON / OFF • ON: 3 BLUE flashes + ascending tone
• OFF: 3 RED flashes + descending tone
+ -
Tap or to adjust and set volume of current audio
Volume
source
Mute / Unmute + -
Tap and
In Standby, press
• Blue LED = Full charge
Battery level indicator
• Purple LED = Half charge
• Red LED = Almost empty
In Standby, press
Enter Settings Menu
instructions
Hear Your Buddy
In Standby, tap
Name
In Standby, press
Paired Device
If "1+8" Buddies are within range, purple LEDs flash for
Indication
2 seconds
Enable / Disable VOX In Standby, press
(For Intercom / Voice
• Enabled: Blue flash for 2 seconds
command calls only)
• Disabled: Red flash for 2 seconds
Enable / Disable
µ s
Press and
Spoken Status
Announcements
simultaneously
+ -
and for 5 seconds
µ
for 2 seconds and follow the spoken
s v
and simultaneously
s v
and for 2 seconds
+ -
and for 2 seconds
for 2 seconds

5.2 STATUS LIGHTS

Main unit LED indication
None
1 BLUE flash every 3 seconds
2 BLUE flashes every 3 seconds
1 RED flash every 3 seconds
2 RED flashes every 3 seconds
Solid RED

5.3 AUDIO SOURCES AND PRIORITIES

If two connected audio sources try to play audio simultaneously, the
SRC-System™ PRO automatically determines which to play through the speakers
based on the priority of the connected devices.
Higher Priority
1. Mobile Phone or GPS instructions

2. Intercom
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
*GPS instructions from Smartphone GPS Apps are
Lower Priority
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt ongoing A2DP music
• Click-to-Link, Intercom and "1+8" calls have the same priority:
Click-to-Link requests will not interrupt any type of Intercom call in progress, and
vice-versa
A2DP audio priority can be configured to be higher than Intercom. See section 4 to adjust settings.
Status
SRC-System™ PRO is OFF
Standby mode – No active audio
Active mode – Call in progress / music or
other audio source is ON
Standby mode – Battery is low
Active mode – Battery is low
USB connected / Charging
*
prioritized like A2DP audio
|
SRCS Pro
11