Intercom With Channels "A" And "B - SCHUBERTH SRC SYSTEM PRO Guía De Usario

Ocultar thumbs Ver también para SRC SYSTEM PRO:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.1b PAIRING WITH A "1+8" INTERCOM BUDDY
1. In Standby, press
s
for 5 seconds to enter pairing mode.
2. Enter "1+8" intercom pairing mode on the second unit. After a few seconds the
units should recognize each other.
3. If pairing was successful, a purple light appears for 2 seconds.
If your SRC-System™ PRO already has a full list of 8 paired "1+8" Intercom Buddies,
pairing another buddy will replace the buddy that you have not spoken to for the longest
time.
Pairing Online – Cardo Community®
You can also find your friends and add them to your "1+8" Buddy list via the
Cardo Community (see section 3).
6.1c PAIRED DEVICE INDICATION
You can see which units within a range of 20m are your "1+8" Intercom Buddies.
s
In Standby, press
Paired Device
If "1+8" Buddies are within range, the LEDs on both units will
Indication
turn PURPLE for 2 seconds
6.1d CALLING "1+8" INTERCOM BUDDIES
There are two ways to start an intercom call with "1+8" buddies.
OPTION 1: Voice Connect (VOX)
Speak any word loudly into the microphone. When you hear the Voice Command
tone, say the name of a "1+8" Intercom Buddy i.e. "John Smith"
|
SRCS Pro
14
v
and
for 2 seconds
OPTION 2: MANUAL MODE
CHOOSE THE NAME
SAY THE NAME
(from your Buddy List):
s
Press
for 2 seconds. Hear the names of all pre-
paired "1+8" buddies.
s
Tap
and say
When you hear the name of the Buddy you wish to call,
the name of the
s
tap
or say any word loudly into the microphone.
"1+8" Buddy
To cancel Buddy List playback: Press
INTERCOM-TO-PHONE
If a "1+8" Buddy is not in range, or moves out of range, you have the option to
set up the "Intercom-to-Phone" feature via the Cardo Community, to remain in
contact by diverting Intercom calls automatically to your mobile phones.

6.2 INTERCOM WITH CHANNELS "A" AND "B"

Start multi-party conversations using Intercom Channels "A" and "B". This mode
is suitable for 2, 3 or 4-way calls.
6.2a PAIRING INTERCOM CHANNELS "A" AND "B"
Pairing a Channel will replace any existing paired device on that Channel with the
newly paired device.
1. Check that all units are in Standby.
2. Press
v
for 5 seconds until the LED begins flashing rapidly, indicating it is in
Intercom Pairing mode (see table below for channel pairing).
CHANNEL
PAIRING METHOD
v
In Standby, press
for 5 seconds. Channel
"A"
"A" pairs automatically.
v
In Standby, press
for 5 seconds.
"B"
When LED begins flashing , tap
s
for 2 seconds.
LED INDICATORS
Rapid RED flashing
Rapid BLUE flashing
v
twice.

Publicidad

Tabla de contenido
loading

Tabla de contenido