Installation; Removing The Existing Acoustic Collar; Connecting The Antenna Cable - SCHUBERTH SRC SYSTEM PRO Guía De Usario

3. INSTALLATION

3.1 REMOVING THE EXISTING ACOUSTIC COLLAR

First, remove the existing Acoustic Collar from
your helmet as follows:
1. Open both snap buttons.
2. Pull out the Acoustic Collar from the rear at
its bended center.
3. Release the collar's pins from their
corresponding indentations inside the
helmet's rim.

3.2 CONNECTING THE ANTENNA CABLE

Your SRC-System™ PRO has an antenna cable which must be connected to the
built-in antenna cable connector in the Schuberth helmet.
Make sure to close the cover of the USB
connector, and then tuck it away into the USB
connector pocket.
1. Pull out the antenna connector (marked with a red tag) which is tucked inside
the back rim of the helmet.
Antenna tag visible
2. On the SRC collar open the two fasteners on the
antenna connector and remove the protective
plastic cover.
3. On the helmet remove the rubber protector from
the antenna connector.
4. Align the two connector heads and snap the two
fasteners back into place to lock the connector in
a closed position.
Antenna connector
pulled out
A. B.
A.
B.
|
SRCS Pro
7