Factory Reset; Confirming/Resetting Alarm Signals And Alarms; Low Battery - VOSS.farming FM10 Instrucciones De Operación

9.6

FACTORY RESET

If you reset the device to factory settings:
ऀ All paired devices are deleted
ऀ All empty list lines are formatted
ऀ The display contrast and backlight settings are reset
ऀ The sound settings are reset
1. Press and hold the Menu button in the overview window or the detail window for
more than one second to open the menu.
2. Select the
About
briefly pressing the Enter button.
3. Press and hold the Enter button for more than one second.
A window for confirming the factory reset opens (
4. Use the arrow buttons to confirm the reset with
.
Cancel
Info
A factory reset can also be cancelled by briefly pressing the Exit button.
5. Confirm the selection by briefly pressing the Enter button.
9.7

CONFIRMING/RESETTING ALARM SIGNALS AND ALARMS

The Fence Manager indicates the following errors using the alarm:
ऀ Low battery
Battery icon flashes if the voltage drops below 12 V. If the alarm is activated (see
ƒ
Section 8.2), the alarm will sound if the voltage drops below 11.6 V.
If the alarm is activated (see Section 8.2), the alarm will sound if the battery
ƒ
charge of the Fence Manager drops below 10%.
ऀ Voltage drop: If the output voltage of the electric fence energiser or the measured
voltage of the Fence Sensor fall below the set limit values, the kV icon will flash and
the alarm will sound if it is activated (see Section 8.2).
ऀ Signal loss (Fig. 12): Dashes will be displayed instead
of the values of the electric fence energiser, the signal
level icon will flash and the alarm will sound if it is
activated (see Section 8.2).
If an alarm is triggered on the Fence Manager, it is displayed
as follows:
ऀ The information that indicates the error flashes on the
display.
ऀ The normally open contact of the external alarm closes
ऀ If activated (see Section 8.2), an audible alarm is
triggered.
46
INSTRUCTION MANUAL VOSS.FARMING FENCE MANAGER FM10
menu item using the arrow buttons and confirm the selection by
FACTORY RESET
or to cancel the reset with
Yes
).
Fig. 12
41650 | 12 | 2020 | V2