Kichler 35164 Manual De Instrucciones página 9

REMOTE CONTROL
REMOTE CONTROL
Fan
Stop
The remote control comes with a cradle that may be
attached to the wall with the included screws.
Setting The Code For The Remote Control:
- Turn off power.
- Remove battery cover.
- Set code using dip switches.
- Press "Set" button for 3 to 5 seconds within 30 seconds after turning on the power.
NOTE: The fan will run for a while and stop to finish setting the code.
Remote Buttons:
Stop the fan
Fan speed - I being the slowest setting and increasing as
to
you move up the numbers to IV. Fan will remember last
setting when powered off and then back on.
Directional Button:
This button changes the fan direction from
forward to reverse.
• In warmer weather, counterclockwise movement of the fan will result in downward
airflow creating a wind chill effect.
• In cooler weather, clockwise movement of the fan will result in upward airflow that can
help move stagnant hot air off the ceiling area.
FRONT
Speed
Control
Directional
Button
REMOTE CONTROL
Remove the remote
control battery cover
and insert battery
(included) with regard
to polarity (+/-).
Replace battery cover
when finished. If the
remote control is not
used for long periods
of time you should
remove the battery to
prevent damage to the
Dip
transmitter.
Switch
Remote Cradle
9
BACK
Set
Button
23A 12V
Battery
Cradle Screws