Using Your Ceiling Fan - LUCCI Air NORDIC Manual De Instrucciones

Nordic Installation Instructions
LIGHT KIT INSTALLATION
CAUTION – To reduce the risk of electric shock, disconnect the electrical supply circuit to the fan before
installing light kit. Ligth kit weight: 1.2 lb.
1. Remove the bottom cover (1) from the body of the fan by rotating it anti-clock wise.
2. Remove the heat shrink insulation tube from connector 3 at the fan body end.
3. Plug the connectors (3) together.
4. Attach the LED luminaire (4) to the light kit bracket (2) and secure by rotating it clockwise.
Pairing Transmitter and Receiver
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.

Turn OFF the mains supply to the receivers of the ceiling fan.

Install the 3V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.14

Turn on the power to fan.

Press and hold the "
ON to the receiver of ceiling fan.
If the fan has light kit attached, the light will flash on and off to indicate the pairing process is activated.

Turn ON and change the speed of the ceiling fan by the transmitter to check the operation and successful
pairing.
Note: The fan supports control by up to 2 transmitter. To reset the fan to only can be controlled by one
transmitter, do the pairing process twice, but press and hold the "
10 seconds.
6 | P a g e

USING YOUR CEILING FAN

" button of transmitter for 3-5 seconds within 60 seconds of switching the power
Fig. 13
" button of transmitter more than
WA-3B-LK