Using Your Ceiling Fan - LUCCI Air AIRFUSION Manual De Instrucciones

Type A Installation Instructions
Pairing Transmitter and Receiver
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.

Turn OFF the mains supply to the receivers of the ceiling fan.

Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.12

Turn on the power to fan.

Press and hold the "SET" button of transmitter for 3-5 seconds within 60 seconds of switching the power
ON to the receiver of ceiling fan.

Turn ON and change the speed of the ceiling fan by the transmitter to check the operation and successful
pairing.
Fig. 12
Pairing Transmitter and Receiver – when 2 or more DC ceiling fans are installed in one location
When two or more fans are located near each other, you may want to have the receiver/transmitter for each
fan set to a different code, so that the operation of one fan does not affect the operation of the other fan/s.
The DIP switches for the transmitter (remote hand piece) are located in the battery compartment of the
transmitter. Configuring the DIP switches will allow a unique transmission code assigned to each fan ceiling.
Transmitter / Receiver pairing for Ceiling fan 1:

Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.

Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.12

Change the position of the DIP switches in the transmitter 1, so that it will be different to transmitter 2.

Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
6 | P a g e

USING YOUR CEILING FAN