Using Your Ceiling Fan - LUCCI Air AKMANI Manual Del Usuario

Akmani Installation Instructions
Pairing Transmitter and Receiver
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.
NOTE: The pairing of Transmitter and Receiver is not required if only one ceiling fan is installed.

Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.12

Turn ON and change the speed of the ceiling fan by the transmitter to check the operation.
Fig. 12
Pairing Transmitter and Receiver – when 2 or more DC ceiling fans are installed in one location
When two or more fans are located near each other, you may want to have the receiver/transmitter for each
fan set to a different code, so that the operation of one fan does not affect the operation of the other fan/s.
The DIP switches for the transmitter (remote hand piece) are located in the battery compartment of the
transmitter. Configuring the DIP switches will allow a unique transmission code assigned to each fan ceiling.
Transmitter / Receiver pairing for Ceiling fan 1:

Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.

Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.12

Change the position of the DIP switches in the transmitter 1, so that it will be different to transmitter 2.

Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
 Press and hold the "
ON to the receiver of ceiling fan 1.
Once the transmitter is paired with the receiver of ceiling fan 1, it will make a beep sound twice. Turn ON
and change the speed of the ceiling fan 1 by the transmitter 1 to check the operation and successful
pairing.
6 | P a g e

USING YOUR CEILING FAN

" button of transmitter 1 for 6 seconds within 60 seconds of switching the power