Saivod SAP718 Manual Del Usuario página 98

Removing Collected Water
2
Use the continuous drainage option from the middle hole
Note:
Water can be automatically emptied into a floor drain by attaching 14mm inner
diameter hose (not included).
1. Remove the continuous drain cap 1 by turning it counter clockwise then remove
the rubber stopper 2 from the spout.
2. Screw the drain connector to(included
in the package) the spout by turning
clockwise.
ATTENTION:
When using continuous drainage option from the middle hole, place portable
on a level surface and make sure garden hose is clear of any obstructions
and is directed downward. Placing portable on an uneven surface or
improper hose installation may result in water filling up the chassis and
causing the unit to shut off. Empty water in the chassis if shut off occurs,
then check portable location and hose for proper setup.
3. Insert the drainage hose into
drain connector.