Reese 66130 Instrucciones De Instalación página 3

2. Shim will not begin to fit between the head and hitch bar. If this is the case, discard shim and continue
installation. The existing gap is acceptable
3. Shim will not go in far enough to reach bottom hole.
If this is the case, cut shim in half and use only the
top half for the top bolt. Discard bottom half of shim.
CAUTION: Washer MUST BE aligned parallel with teeth on ballmount. Re-check washer alignment after nut is
tightened. Equal number of teeth must show at top and bottom. Teeth can be stripped when loaded if not properly
aligned.
INITIAL HOOK UP
NOTE: Car and trailer should be loaded and ready for travel before final leveling.
1. Pick reference points on front wheel well. Measure and record distance to pavement.
Front wheel well to pavement ___________________
2. Attach chains to spring bars using U-bolts, flat washers, and locknuts. Let 2-3 threads protrude below locknut. Chain
must not bind.
3. Using tongue jack lower coupler onto ball and close coupler latch.
4. Hold the spring bar away from you (trunnion ribbed side up). Set the bottom knob of the trunnion into the lower socket of
the ballmount (G) and slide the knob into the top slot of the ballmount. The spring bars will fit on either side as they are
not made right or left handed.
5. Position the snap up brackets on trailer
"A" frame so that the chain on the end of
the spring bar is approximately vertical.
Turn 1/2 X 3-1/2 bolt until it contacts frame.
Then tighten 1/4 turn with wrench. DO NOT
OVERTIGHTEN.
6. Raise trailer tongue and rear of car with
jack. Lower yoke of snap up bracket until
it is parallel with the ground, and slip the
closest link over the hook (If there are
less than 5 links between hook and u-bolt
adjust ballmount angle rearward, and repeat
procedure). With the snap up bracket
handle over the yoke, raise until yoke
has passed "over-center". Slide the safety
pin through the small hole to lock the yoke
in place. Repeat for other side.
66006IN-05/29/13 REV L
STANDARD SPRING BAR
PCN19360 ©2006 TOWING PRODUCTS, INC
INTEGRATED CAM SPRING BAR
Fig.2
PLACE CLOSEST
LINK ON HOOK
SNAP UP
HANDLE
PRINTED IN MEXICO
3