Checking The Engine-Oil Level; Adjusting The Cutting Height - Toro TurfMaster 22210 Manual Del Operador

1. Fuel-tank cap
Checking the Engine-Oil
Level
Service Interval: Before each use or daily
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil is below the Add mark on the
dipstick, carefully pour a small amount of oil
into the oil-fill tube, wait 3 minutes, and then
Figure 13
(Figure
Figure 14
3. Low
(Figure
repeat steps
at the Full mark on the dipstick.
•
If the oil is above the Full mark on the
dipstick, drain the excess oil until the oil level
is at the Full mark on the dipstick. To drain
the excess oil, refer to
Oil (page
Important:
is too low or too high and you run the
engine, you may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
g209575
Adjusting the Cutting
Height
The cutting heights range from 38 mm (1-1/2 inches)
to 127 mm (5 inches) in 13 mm (1/2 inch) increments.
14).
View from front, left side of the machine
1. 38 mm (1-1/2 inches)
2. 51 mm (2 inches)
3. 64 mm (2-1/2 inches)
4. 76 mm (3 inches)
g194742
The cutting height is controlled with a front lever and a
rear lever, both on the left side of the machine
16 and Figure
engage the lever, raise or lower the machine, and
then disengage the lever.
14).
11
3 through 5 until the oil level is
Changing the Engine
19).
If the oil level in the crankcase
Figure 15
5. 89 mm (3-1/2 inches)
6. 102 mm (4 inches)
7. 114 mm (4-1/2 inches)
8. 127 mm (5 inches)
17). To raise or lower the machine,
g019911
(Figure