Changing The Oil Filter - Toro TurfMaster 22210 Manual Del Operador

Ocultar thumbs Ver también para TurfMaster 22210:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
After draining the used oil, return the machine to
the operating position.
6.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7.
Wait about 3 minutes for the oil to settle in the
engine.
8.
Wipe the dipstick clean with a clean cloth.
9.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10.
Read the oil level on the dipstick
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and
repeat steps
at the Full mark on the dipstick.
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level
is at the Full mark on the dipstick.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11.
Install the dipstick securely.
12.
Recycle the used oil properly.

Changing the Oil Filter

Service Interval: Every 100 hours
1.
Run the engine to warm the oil.
2.
Shut off the engine and wait for all moving parts
to stop.
3.
Disconnect the wire from the spark plug.
4.
Drain the engine oil; refer to
Engine Oil (page
5.
Place a rag under the oil filter to catch any oil
that may leak out as you remove the filter.
Figure 29
(Figure
8
through
10
until the oil level is
Changing the
19).
6.
Remove the oil filter
Note:
off with the filter.
g019648
1. Oil filter
7.
Use your finger to coat the gasket on the new
filter with oil
28).
1. Gasket
8.
Install the new filter until the gasket contacts
the filter base, then hand tighten the filter an
additional 2/3 turn.
9.
Fill the crankcase to the Full line on the dipstick
with fresh oil; refer to
(page
10.
Connect the wire to the spark plug.
11.
Run the engine for about 3 minutes.
12.
Shut off the engine, wait for all moving parts to
stop, and check for oil leakage around the filter.
13.
Add oil to compensate for the oil in the oil filter;
refer to
14.
Recycle the used oil filter according to local
codes.
20
(Figure
Make sure that the oil-filter gasket comes
Figure 30
(Figure
31).
Figure 31
Changing the Engine Oil
19).
Changing the Engine Oil (page 19)
30).
g019650
g002805

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Turfmaster22210

Tabla de contenido