Filling The Engine With Oil; Important - Toro TurfMaster 22210 Manual Del Operador

1. Lowest handle height
setting
2. Middle handle height
setting
3. Tighten the handle bolt until it is snug.
4. Repeat the steps above for the other side of the
machine.
3

Filling the Engine with Oil

No Parts Required
Procedure

Important:

Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine oil capacity: With oil filter: 0.85 L (29 fl oz);
without oil filter: 0.65 L (22 fl oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
Figure 5
3. Highest handle height
setting
(Figure
g021150
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait about 3 minutes for the oil to settle in the
engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and
repeat steps
at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level
is at the Full mark on the dipstick; refer to
Changing the Engine Oil (page
Important:
is too low or too high and you run the
engine, you may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
6).
7
Figure 6
3. Low
(Figure
3 through 5 until the oil level is
19).
If the oil level in the engine
g194742
6).