Removing The Blades; Installing The Blades - Toro TurfMaster 22210 Manual Del Operador

1. Front of cutting deck
2. Measure at locations A
and B
2. Measure from a level surface to the cutting
edges at locations A and B,
record both dimensions.
3. Rotate the blades so that their opposite ends
are at locations A and B.
4. Repeat the measurements in step
them.
Note:
If the difference between dimensions A
and B obtained in steps
inch, replace the blades; refer to
Blades (page 24).
WARNING
A blade that is bent or damaged could
break apart and could seriously injure or
kill you or bystanders.
• Always replace a bent or damaged
blade with a new blade.
• Never file or create sharp notches in
the edges or surfaces of a blade.

Removing the Blades

Replace the blades when they strike a solid object,
are out of balance, bent, or worn. Use only genuine
Toro replacement blades.
1. Use a block of wood to hold each blade steady
and turn the blade bolt counterclockwise as
shown in Figure
Figure 37
3. Measure from the cutting
edge to a smooth, level
surface
(Figure 37), and
2 and record
2 and 4 exceeds 1/8
Removing the
38.
g016532
2. Remove each blade as shown in
1. Spindle (2)
2. Blade driver (2)
3. Inspect the pins on the blade drivers for wear
and damage.

Installing the Blades

WARNING
Incorrectly installing the blades could damage
the machine or cause an injury to the operator
or to bystanders.
Install the blades according to the
instructions.
24
Figure 38
Figure
Figure 39
3. Blade (2)
4. Blade bolt (2)
g016527
39.
g016530