Adjusting The Self-Propel Cable; Storage; General Information; Preparing The Fuel System - Toro TurfMaster 22210 Manual Del Operador

Adjusting the Self-Propel
Cable
If the machine does not self-propel or tends to creep
forward when you release the control bar, adjust the
drive cable.
1. Shut off the engine and wait for all moving parts
to stop.
2. Loosen the cable support nut
Figure 50
3. Pull down the cable jacket (toward the mower)
until there is no slack in the cable
Figure 51
4. Tighten the nut on the cable support.
5. Check the operation for desired drive control.
Note:
If the unit creeps forward without the bail
engaged or if the wheels spin when you lift the rear
wheels off the ground, the cable is too tight; repeat
steps1 and 2.
Note:
Adjustment to obtain desired ground speed at
full bail travel may be made in order to accommodate
slower speeds.

Storage

General Information

Store the machine in a cool, clean, dry place. Cover
the machine to keep it clean and protected.
(Figure 50).
g005013

Preparing the Fuel System

(Figure 51).
Fuel can vaporize if you store it over long
periods of time and explode if it comes into
contact with an open flame.
• Do not store fuel over long periods of time.
• Do not store the machine with fuel in the
• Allow the engine to cool before storing it in
g005011
On the last refueling of the year, add fuel stabilizer
to the fuel as directed by the engine manufacturer.
Empty the fuel tank when mowing the last time before
storing the machine.
29
1. Perform the recommended annual maintenance
procedures; refer to
2. Clean under the machine; refer to
under the Machine (page
3. Remove chaff, dirt, and grime from the external
parts of the engine, the shrouding, and the top
of the machine.
4. Check the condition of the blades; refer to
Inspecting the Blades (page
5. Service the air filter; refer to
Filter (page 19).
6. Tighten all nuts, bolts, and screws.
7. Touch up all rusted or chipped paint surfaces
with paint available from an Authorized Service
Dealer.
WARNING
fuel tank or the carburetor in an enclosure
with an open flame. (For example, a
furnace or a water heater pilot light.)
any enclosure.
1. Run the machine until the engine shuts off from
running out of fuel.
2. Start the engine again.
3. Allow the engine to run until it shuts off.
When you can no longer start the engine, it is
sufficiently dry.
Maintenance (page 18).
Cleaning
16).
23).
Servicing the Air