LUCCI Air AIRFUSION ARIA CTC Manual De Instalación página 13

Aria CTC Installation Instructions
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through
this section and get familiar with the buttons and function of
each button.
LED Indicator
The red LED indicator on the top of the transmitter will flash
when the buttons are active.
BUTTONS ON THE REMOTE
HI: Press the button to set fan running at High speed.
MED: Press the button to set fan running at Medium speed.
LOW: Press the button to set fan running at Low speed.
OFF: Press the button to turn OFF the fan.
LIGHT CONTROL
: Press the button to turn ON/ OFF the light.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorize
and recover the last status when turned on next.
The LED Light Kit has a 3-step dimmable function which is controlled by an ON/OFF switch. Toggle the
switch ON/OFF to the luminaire 4 times within 5 seconds, the globe will light up in the following order:
100% brightness → 60% brightness → 10% brightness → 100% brightness
To switch back to 100% brightness at any stage, turn OFF the luminaire, and then after 5 seconds turn
ON the luminaire, it will reset to 100% brightness.
INSTALLATION OF THE REMOTE CONTROL HOLDER (Fig. 15)
1. Locate a suitable wall or surface to
fix the remote control wall holder.
2. Remove the screw cover and install
the holder using the 2 screws and
re-install the screw cover. (Fig.15a).
3. Slide the remote into the holder.
(Fig. 15b).
12 | P a g e
Fig. 15a
Fig. 14
Fig. 15b
ARIA CTC V1.0
EU (2019/11)