LUCCI Air AIRFUSION ARIA CTC Manual De Instalación página 4

Aria CTC Installation Instructions
Example: If a fan is connected to a circuit that can be isolated via an
all-pole safety switch at the switchboard, then this is considered to
be an all-pole disconnection to the ceiling fan electrical circuit,
meeting the requirements of clause 7.12.2 of AS/NZS 60335.1.
A single-pole switch on the active of the receiver input of remote
control must also be included in the wiring, and located the
same room as the ceiling fan.
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
5.
facilities. Contact your local government for information regarding the collection systems available. If
electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the
ground water and get into the food chain, damaging your health and well-being.
The structure to which the fan is to be mounted must be capable of supporting a weight of 30kg.
6.
The fan should be mounted so that the blades are at least 2.3 m above the floor in Europe or 2.1 m
7.
above the floor in Australia.
This fan is suitable for indoor, alfresco and coastal areas where the fan is fully undercover with a
8.
minimum of 1 wall. This fan is not waterproof. When installed in an alfresco or coastal area, the
ceiling fan must be positioned in a location protected from water, wind and dust. Exposure to these
elements will void the warranty. Mounting the fan in a situation where it is subject to water or moisture
is dangerous and may increase the risk of damage, injury or electrical shock and will void the warranty.
Must be assembled and installed by a licensed electrician.
9.
10. WARNING: If unusual wobbling or oscillating movement is observed, immediately stop using the
ceiling fan and contact the manufacturer, its service agent or suitably qualified persons.
11. The replacement of parts of the safety suspension system device shall be performed by the
manufacturer, its service agent or suitably qualified persons.
12. The fixing means for attachment to the ceiling such as hooks or other devices shall be fixed with a
sufficient strength to withstand 4 times the weight of the ceiling fan; that the mounting of the
suspension system shall be performed by the manufacturer, its service agent or suitably qualified
persons.
3 | P a g e
ARIA CTC V1.0
EU (2019/11)