Defrosting; Door Conversion - Infiniton CL-189XY Manual De Usuario

DEFROSTING

Refrigerator compartment defrosts fully automatically
While the refrigerating unit is running, beads of condensation or hoarfrost from at the back of the refrigerator compartment.
This is normal. It is not necessary to wipe off the condensation or frost. The rear panel defrosts automatically. The condensation
runs into the condensation channel and is conveyed to the refrigerating unit where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation can run out.
Defrosting the freezer compartment
The freezer compartment does not defrost automatically, otherwise the frozen food would start thawing.
A layer of frost in the freezer compartment impairs refrigeration of the frozen food and increases power consumption. Remove the layer of hoarfrost
regularly.
Do not scrape off hoarfrost or ice with a knife or pointed object. Doing this may damage the refrigerant tubes.
1. Remove the frozen food and place temporarily in a cool location.
2. Disconnect the mains plug from the mains socket.
3. To accelerate the defrosting process, place a pan of hot water on a stand in the freezer compartment.
4. Wipe up condensation with a cloth or sponge.
5. Wipe dry the freezer compartment.
6. Plug in the appliance and adjust the temperature control knob as desired.
7. Put the frozen food back in the freezer compartment.

DOOR CONVERSION

If you need to hinge your fridge and freezer doors on the opposite side it is recommended that you call your local authorised service agent to make this
conversion or ask a technician. The below drawings are only for reference.
Before you reverse the doors, you should ensure the appliance is unplugged and empty. It is recommended to use a crosshead screwdriver and a spanner
(both not supplied).
Remove the right upper hinge cover and upper
hinge hole plug.
1

Remove the cylindrical light switch fixed on
the right upper hinge cover.
Remove the right upper hinge and door cover
hole plug.

Open the door cover hole plug, put the
2
wiring harness terminal of the door into the
door cover slot, and close the door cover hole
plug.
Lift the door upwards to disengage it from the
3
middle hinge, put the door to one side and lay it
down gently on a padded surface.
4
Remove left feet and right lower hinge.
EN-11