Replacement Of Ir Receiver Module Pcb11 - Bang & Olufsen BeoVision 1 Guía De Servicio

Place main chassis in correct position
Disconnect the ESD mat from the main chassis
Finish the on-site service

#10 Replacement of IR receiver module PCB11

Place main chassis in service position
Disconnect 10P033
Remove the contrast screen
Replace PCB11
Mount the contrast screen
Reconnect PCB11
Place main chassis in correct position
Finish the on-site service
- Place main chassis in correct position and fasten the screws.
- Remove the alligator clip from the aerial input on the main chassis.
- See #17 Check after replacement of main chassis or modules, to finish the
on-site service.
- Unscrew the 2 screws in the main chassis holder and place the main chassis in
service position. See #5 Main chassis in service position for further information.
- Disconnect 10P033 on PCB10 (see
cable.
- Remove the contrast screen, see #15 Removal of the contrast screen for further
information.
- Remove PCB11 (see
flatcable through the front frame.
- Mount the contrast screen, see #15 Removal of the contrast screen for further
information.
- Place the flatcable in the holder and reconnect 10P033 on PCB10 (see
a pair of tweezers to lock the cable.
- Place main chassis in correct position and fasten the screws.
- See #17 Check after replacement of main chassis or modules, to finish the
on-site service.
6), using a pair of tweezers to unlock the
14) by pulling it outwards. Replace PCB11. Place the
Replacement, English
6), using
2.15