Bang & Olufsen BeoVision 1 Guía De Servicio página 22

2.18 Replacement, English
Place the new module in the Beo1
Turn the red plastic piece 90° to the right
Mount the new secondary set of buttons
Fasten the screws and place the label
Insert the batteries and mount the battery cover
Test the Beo1
- Push the new module into the shell. Make sure the primary set of buttons is in
place, before pushing the module into the shell.
- Turn the red plastic piece 90° to the right, according to the direction of the arrow.
- Mount the new secondary set of buttons. Make sure the end marked STOP, is
facing the top of the Beo1.
- Fasten the screws in the bottom and mount the old label. Make sure the hole for
the battery cover screw is free.
- Insert the batteries, check the label to place them correctly. Mount the battery
cover, push it down and fasten the screw. Make sure the cover is placed
correctly.
- Test all the functions of the Beo1.