Bang & Olufsen BeoVision 1 Guía De Servicio página 26

2.22 Adjustments, English
Exit Service Mode
Adjust geometry in format 2 (16:9)
Exit Service Mode
Horizontal BOW (BOW)
- Adjust BOW until the vertical lines at the sides of the picture are straight.
Please note:
It may be necessary to repeat some of the adjustments.
Only the adjustments mentioned have to be done.
- Enter SETUP and select PICTURE FORMAT. Select FORMAT 16:9 with GO.
- Enter SETUP, select SERVICEMODE with STOP, STOP, GO. Press the button
combination within 3 seconds. Select MONITOR and select GEOMETRY
ADJUSTMENTS. When selecting a parameter, the picture should change to
format 16:9.
- Select the parameter to change by means of
parameter by means of
Press GO to store the new settings.
Horizontal Amplitude (H-AM)
- Adjust H-AM to the correct width of the picture.
Vertical Amplitude (V-AM)
- Adjust V-AM so that the picture fits at the top and bottom, there must be
approx 10 cm. from the bottom of the circle to the bottom of the visible screen.
Vertical SHift/centering (V-SH)
- Adjust V-SH until there is approx. 8mm. from the top of the circle to the top of
the visible screen.
East/West Parabola (EW-P)
- Adjust EW-P to the correct geometry at the sides. The middle part of the vertical
lines must be as straight as possible.
East/West Upper Corner (EWUC)
- Adjust EWUC to the correct geometry at the upper corners.
East/West Trapezium (EW-T)
- Adjust EW-T to the correct geometry.
Horizontal PArallelogram (H-PA)
- Adjust H-PA to the correct geometry.
Please note:
It may be necessary to repeat some of the adjustments.
m
and
m p
and . Change the settings by means of
p
and press GO. Change
l n
and .