Installation Steps; Care And Cleaning - AVS Bugflector Instrucciones De Instalación

Installation Steps

Center hood shield and attach outer flanges with exposed tape.
Remove tape liner. Attach center flanges with screws.
Bump On
3/4" (1.9 cm)
washer
screw
3
NOTE: The hood shield should be offset approxi-
mately 3/4" (1.9 cm) from the front edge of hood.
Hood Hood shield Washer
5

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from drawings.
or
Bump On
washer
screw
screws
tape
Do No Overtigthen
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2010 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo, Chromeflector
TM TM
Apply pressure to tape flange.
4
Lower hood, adjust hood bumper stops if necessary.
6
, and the AVS logo are trademarks of Lund International, Inc.
TM TM
Page 2 of 2
Apply bump-ons to hood surface.