Safety Instruction; Engine Assembly And Engine Machine Coupling - TOYAMA TDWE 8 Guia Del Propietario

2. SAFETY INSTRUCTION

✓ It is forbidden to touch parts at high temperature such as water radiator and muffler
(exhaust), and moving parts such as the steering wheel and starter shaft to prevent burns
and injuries. Keep the fuel tank away from fire and never direct the exhaust from
flammable products such as straw, mounds of grass and cotton to avoid any scratches.
✓ Children, the elderly who move slowly and people with abnormal behavior should not be
allowed in the workplace.
✓ When coupled with the driven engines, the motor must develop its nominal power at rated
speed as specified at the manual, avoid operating the motor with overload, over speed
or with low load and at low speed for a time of 5 minutes.
✓ Use fuel and lubricating oil to the specified degree, and before use, must be thoroughly
filtered. Any utensils used should be kept clean. The used lubricating oil should be
changed periodically. The fuel filter element and the crankcase filter screen should be
cleaned periodically.
✓ Fill the oil filter with oil to the level line. Cleaning, maintenance and oil change should be
carried out regularly. When the engine is used in very windy and dusty conditions,
cleaning, maintenance and oil change should be performed every day.
✓ Clean fresh water is used for cooling water. The engine must operate under boiling
conditions of the cooling water in the radiator. The amount of water must be maintained
so that the red ball of the float should not be below the mouth of the radiator hopper.
✓ Regularly check the mounting connection and tighten the bolts of the engine parts. If you
find any loose parts, tighten immediately. (Engine sockets are provided for use during
transportation, cannot be installed in the motor for normal operation, which could damage
the motor.)
✓ The gearbox mounted fuel controller has been adjusted and sealed prior to dispatching
the engine. Do not remove or adjust randomly.

3. ENGINE ASSEMBLY AND ENGINE MACHINE COUPLING

Engine assembly
The motor must be screwed into a rigid base with the same mounting dimensions of diesel
engines of this type.
The axial dimensions of the pulley of the driven machine must coincide with those of the motor to
prevent twisting of the belts. The motor and the driven machine must be tightly coupled. Measures
must be taken to protect the steering wheel and belt pulley to avoid risk of accident.
7