Deck Installation - Swing-N-Slide Timber-Bilt Turbo Tube Slide Instrucciones De Ensamble

ASSEMBLY INSTRUCTIONS
2" x 6" x 27-1/4"
82-1/2" to ground
82-1/2" a la tierra
82 1/2 po jusqu'au sol
2" x 4" x 40-1/4"
20

DECK INSTALLATION

FIGURE 4
1. Attach two 2" x 6" x 45-1/2" deck
2. Drill 3/8" holes through the 2" x 6"
2" x 6" x 45-1/2"
3. Place 2" x 6" x 27-1/4" spacer board
2" x 6" x 45-1/2"
4. Place the 2" x 4" x 30-1/4" deck board
FIGURE 5
5. Place the 2" x 4" x 40-1/4" on the
6. Evenly space six 2" x 6" x 40-1/4"
2" x 6" x 40-1/4"
(6 total)
2" x 4" x 30-1/4"
supports to the unit as indicated in
Fig. 4 using four 3" screws per joint.
NOTE: The tops of these boards
should be approximately 82-1/2" from
the ground and should be level.
and 4" x 4" joints of the deck supports
as indicated. Counterbore the
4" x 4" approximately 1/2" deep at
each hole location. Secure each joint
using a 5" carriage bolt, wood loc
washer, washer and loc nut.
between the deck supports and attach
using two 3" screws per joint. NOTE:
Do not allow screws to split the
surface of the 2" x 6" x 27-1/4" spacer .
If this occurs, back out screw and
reposition.
between the 4" x 4" posts as shown in
Fig. 5. Attach to the deck support
using two 3" screws per joint.
supports as indicated in Fig. 5.
NOTE: The 2" x 4" x 40-1/4" deck
board should be tight against the
corresponding 4" x 4" posts and
should extend approximately 1-1/2"
past the edge of each post. Attach
using two 3" screws per joint.
boards between the previously
attached deck boards. NOTE: The
2" x 6" x 40-1/4" deck boards should
extend approximately 1-1/2" past the
edge of each post. Attach using two 3"
screws per joint.