Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Do not start the engine if any petrol
has been spilt.
Push the mower away from the
area where the petrol was spilt and
wait until the petrol fumes have
evaporated.
To prevent a fire hazard, keep the
following parts free from grass and
leaking oil: Engine, exhaust, fuel
tank.
!
Danger
Injury hazard due to defective
mower
Do not operate the mower if it is not
in perfect working order.
Before operating the unit, always
carry out a visual inspection. Pay
particular attention to safety devices,
the cutting mechanism and its sup
porting brackets, operating controls
and threaded connections, and
check that they are not damaged
and are securely attached.
Replace damaged parts before ope
rating.
!
Danger
Risk of injury
While the engine is running or hot,
do not check, inspect or service/ad
just the mower.
Operating times
Comply with the national/municipal
regulations concerning the times
when the mower may be used
(if required, contact your local autho-
rity).
Before operating the unit,
always
Check:
all guards,
the engine oil level (see engine
manual),
the fuel level,
the tyre pressure,
ventilation slots in the engine
area for dirt and grass clippings.
Fill up with fuel and check the
oil level
Fig. 5
Note
The engine has already been filled
with oil at the factory – please check
the oil, if required refill.
12
Fill up with lead-free petrol.
See engine manual.
Fill fuel tank up to max. 2.5 cm
below the lower edge of the inlet
nozzle.
Close fuel tank tightly.
Check the oil level. The oil level
must be between the "Full/Max."
and "Add/Min." mark (see also
engine manual).
Check tyre pressure
Note
For production reasons the tyre
pressure may be higher than requi-
red.
Check tyre pressure. If required,
correct (see section
"Maintenance"):
– front:
– Rear:
-
Adjusting the driver's seat
Fig. 2
Move seat to the required positi-
on.
-
Starting the engine
Information about the engine
Observe the information in the engi-
ne manual.
– Some models have no throttle and
-
the speed is adjusted automati-
cally. The engine always runs at
optimum speed.
– Some models have no choke and
no primer. The engine is automati-
cally set to the particular starting
process.
Turn on the fuel tap (if fitted – see
engine manual).
Sit on the driver's seat.
Switch off and raise the cutter
deck:
– Move PTO lever to the Off po-
sition
.
– Set cutting height adjustment
lever to "5" (cutter deck up).
Actuate the parking brake.
Move direction of travel lever
to "N".
Move the throttle (if fitted) to
If the engine is cold, pull out the
choke (if fitted) or set the throttle
(if fitted) to
.
Operating Manual for Ride-on Lawn Tractor
Stopping the engine
1.0 bar
0.7 bar
Driving
!
Abrupt starting, sudden stopping,
and driving at an excessively high
speed increases the risk of acci
dents and may damage the mower.
Be particularly careful when rever
sing.
mower.
Never change the direction of travel
without first bringing the mower to a
standstill.
Stopping the mower
Mowing
.
Turn the ignition key to
the engine is running (start att-
empt max. 5 seconds, wait 10 se-
conds before the next attempt).
When the engine is running, set
the ignition key to
.
As soon as the engine is running,
slowly push back the choke/
throttle (if fitted) until the engine
is running quietly.
Set throttle (if fitted) to the middle
position.
Leave the engine running for ap-
prox. 20 seconds.
Set ignition key to
Remove the ignition key.
Before leaving the mower, actua-
te the parking brake.
Danger
Caution. Damage to the
Start the engine as indicated.
Release the parking brake:
Fully depress clutch/brake pedal,
push lever to a speed setting.
Move the direction of travel lever
to the corresponding position.
Slowly release the clutch/brake
pedal, the unit moves off.
Depress the clutch/brake pedal
until the unit stops.
In normal mode
/
(see Operation, ignition lock):
Before reversing the machine,
switch off and raise the cutter
deck.
until
.
-
-
Publicidad
Capítulos
Tabla de contenido
