Chapter 2 Setup Procedures; Connecting To The Lan Line; Network Configuration; Setting Procedure - Christie LX1750 Manual De Instrucciones

Chapter 2 Setup Procedures

Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.

Connecting to the LAN line

Connect the LAN cable to the LAN connection terminal of the projector.
* Please use a shielded LAN cable.

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be
made with a browser. Refer to "3. Basic setting and operation" (p.17-30). First, complete the
settings described in this chapter before performing steps in "3. Basic setting and opera-
tion."

Setting Procedure

1. Select "Network" in the Network menu, and press Point w or SELECT.
2. Select "On" with Point as, and press SELECT. Then the Menu will disappear, the
"Please wait..." message will appear, and switching operation will start. Switching will
take a while and the projector's LINK/ACT Lamp will be on or blink, and after completing
the operation, the "Please wait..." message will disappear.
12
LAN Connection Terminal
LAN Cable
ACT Lamp (Orange)
Blink orange when the
projector is sending or
receiving the data.
LINK Lamp (Green)
Light green when the
projector is connected to
the network correctly.
LX1750 Network User Manual
020-000639-01 Rev.1 (11-2013)