Examples: Type And Contents Of Alert Mail - Christie LX1750 Manual De Instrucciones

Chapter 3 Basic Setting and Operation

Examples: Type and contents of alert mail

When the projector has an abnormality, the following alert messages are sent to the regis-
tered E-mail address according to your selected condition. Administrator or user can take
an efficient action quickly by receiving this message. This is very useful to maintain and
service the projector.
The following are examples of received messages.
● When internal PJ temperature is too high:
TITLE: Message from projector
Projector Model Name: model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends the following message.
* T he projector lamp is turned off, because internal temperature goes over the safety limit.
Wait for the completion of the cooling process and make sure the projector has been
turned to Standby. Then turn the projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
● When PJ needs service:
* M aintenance requirement from Projector is detected.
Check up LED status of projector and consult with the dealer.
AD, 3.3V
KS, 3.3V
--- ---
MAIN, 3.3V
--- ---
✐ The projector lamp was turned off, because the projector power circuit failed.
Unplug the AC power cord and plug it, and then turn on the projector once again to verify
operation. If the problem still persists, unplug the AC power cord and ask servicing to a
qualified service personnel with the error information.
● When PJ lamp replacement time is reached:
* T he projector lamp 1 has reached replacement time.
Lamp 1 ON 2000 h
Lamp 2 ON 1800 h
✐ Replace it with a new lamp immediately and reset the lamp counter. If the projector is
used without resetting the lamp counter, the alert mail is sent to users in every power-
on of the projector. This alert mail will not be sent when unchecking the mail sending
condition "When PJ lamp replacement time is reached".
28
OK
OK
---
NG
Error information
---
E-mail Header
LX1750 Network User Manual
020-000639-01 Rev.1 (11-2013)