5�5�1 Acoustic Signal (Buzzer) - Renfert SILENT TC Manual De Instrucciones

5.5.1 Acoustic signal (Buzzer)
When on, various inputs are confirmed with an acoustic signal.
To change:
⇒ Press operating mode key (21) for 3 sec�
♦ Starting the programming mode�
⇒ Press operating mode key 1 x again�
♦ In the display a „b" blinks�
⇒ Press Enter key (27)�
♦ Acoustic Signal selected�
♦ The decimal point blinks: The acoustic signal is switched on�
♦ The decimal point is off: The acoustic signal is switched off�
⇒ Switch the acoustic signal on or off with the [+] / [-] keys�
⇒ Press Enter key (27)�
♦ Save changes, exit programming mode�
5.5.2 Time Interval for "Full" Display Dust Drawer
After reaching a set time interval, a request appears to empty the dust drawer�
It is possible to select one of 5 different times�
Time interval / hrs
2
5
10
50
100
In the case of heavy dust generators (e.g. blasting equipment), the time interval "emptying the
dust drawer" should be set to 5 hours, if necessary to 10 hours.
⇒ Press operating mode key (21) for 3 sec�
♦ Starting the programming mode
⇒ Press operating mode key 2 x again�
♦ In the display "A" blinks�
⇒ Press Enter key (27)�
♦ Time Interval for "Full" display Dust Drawer selected�
♦ In the display (24), "A" and a number for the time interval will be shown
alternately�
⇒ Set the required time interval with the [+] / [-] keys�
⇒ Press Enter key (27)�
♦ Save changes, exit programming mode�
Value in display (24, Fig. 2)
1
2
3
4
5
- 11 -
21
Factory setting
21
EN
23 25 27
Fig. 9
23 25 27
Fig. 10