Installation; General Information - edenox DBM-211-S-W Manual De Instrucciones

 operating without protective clothing;
 carrying or transporting the device without a pallet or a suitable platform.
The manufacturer shall not be held liable for any damage attributable to the failure to follow
the instructions contained in this manual, hence it is recommended that you carefully read all
information herein.
Keep the manual for later use.
Warning!!!
Do not use the device if it is faulty.
1.3 TECHNICAL PARAMETERS.
EXTERNAL
MODEL
DIMENSIONS (mm)
length
DBM-211-S-W
790
DBM-311-S-W
1115
DBM-411-S-W
1440
DBM-511-S-W
1765
2. INSTALATION

2.1 General information.

2.2 Transport, lifting, unpacking, storage.
2.3 Intended use and limitations.
2.4 Layout and description of the manufacturer's rating label.
2.5 Installation and assembly.
2.6 Connections (electricity, gas, and water).
2.1 GENERAL INFORMATION.
The water bain-marie should be unpacked, installed and tested by qualified service personnel.
After being brought into the room where it is going to be installed, the device should be left for
approximately 6 hours so that it can achieve the ambient temperature. Then it can be connected to
power supply.
The conductors diameter of the power cable should not be smaller than the values given in the table
below.
2
edenox.com
CAPACITY
GN 1/1
width high
610 304 2 x GN1/1
610 304 3 x GN1/1
610 304 4 x GN1/1
610 304 5 x GN1/1
*CUTOUT
VOLTAGE
DIMENSIONS
(V/Hz)
(mm)
length width
770 585 230/50
1095 585 230/50
1420 585 230/50
1745 585 230/50
ENGLISH
POWER WEIGHT
(W) (kg)
1600
2400
3000
3000 37