Installing Micro Serial Port And Power Connector Port; Cámara Frontal; Removing Front Camera - Dell Latitude 12 Manual Del Propietário

Installing micro serial port and power connector port

1. Insert the power connector port and micro serial port into the slot on the chassis.
2. Align the metal brackets that secure the ports on the system chassis.
NOTE: The USB-C port bracket is followed by the micro serial port bracket, as the micro serial port bracket sits on top
of the USB-C port bracket with screw (1).
3. Replace the screws (5) to secure the micro serial port and power connector port to the chassis.
4. Align the rubber bracket and push to slide in the channel .
NOTE: Rubber bracket ensures to secure the micro serial port cable from damage.
5. Insert the micro serial port cable into the connector.
6. Close the latch to secure the micro serial port cable to the system board.
7. Align the power connector port cable to the system board and affix the ground wire with the screw (1) to the system board.
8. Install the:
a. Display assembly
b. Battery
9. Follow the procedure in
Cámara frontal

Removing front camera

1. Follow the procedure in
2. Remove the:
a. Battery
b. Display assembly
3. To remove the front camera:
a. Place the back side of system on a flat surface.
b. Locate the front camera.
c. Slide the camera shutter towards right, to bring the lens cover is in the open position [1].
d. Insert the edge of the plastic scribe between the gap of lens shutter and lift camera lens shutter [2].
After working inside your
Before working inside your
computer.
computer.
Extracción e instalación de componentes 29