Placa Base; Removing System Board - Dell Latitude 12 Manual Del Propietário

3. Replace the screws (4) to secure the system fan to the tablet chassis.
4. Connect the system fan cable to the system board.
5. Install the:
a. Heat sink
b. Display assembly
c. Battery
6. Follow the procedure in

Placa base

Removing system board

1. Follow the procedure in
2. Remove the:
a. Battery
b. Micro SIM
c. Display assembly
d. Heat sink
e. SSD
f. System fan
g. WLAN
h. WWAN
3. Perform the following before removing the system board:
a. Place the back side of system on a flat surface.
b. Lift the latch, and disconnect the microphone cable from the system board [1].
c. Remove the radio antennae cable from the routing clip with a plastic scribe on the system board [2],[3],[4].
d. Lift the latch, and remove the fingerprint reader cable [5].
e. Remove the CMOS battery cable from the connector on the system board [6].
38 Extracción e instalación de componentes
After working inside your
Before working inside your
computer.
computer.