Installing Microphone; Heat Sink For Ssd; Removing Heatsink For Ssd Or Pcie - Dell Latitude 12 Manual Del Propietário

Ocultar thumbs Ver también para Latitude 12:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
NEVER pull the microphone by the cable. In case the circuit board is not released smoothly, push from below
the microphone circuit board by a plastic scribe.

Installing microphone

1. Align the microphone system board on the tablet chassis.
2. Align the microphone input in the slot on the chassis, with the microphone input against the tablet chassis
3. Replace the bracket behind and against the microphone input and replace the screw (1) in the bracket to secure the
microphone to the tablet chassis.
4. Align the microphone IC board on the chassis and replace the screw (1) to secure the IC board to the chassis.
5. Slide the microphone bus cable in the port on system board and close the latch to secure the cable.
6. Install the:
a.
Display assembly
b.
Battery
7. Follow the procedure in

Heat sink for SSD

Removing heatsink for SSD or PCIE

1. Follow the procedure in
2. Remove the:
a.
Battery
b.
Display assembly
3. To remove the heatsink:
a. Place the back side of system on a flat surface.
b. Locate the heatsink.
c. Remove the screws (4) securing the heatsink on the system board [1].
d. Lift the heat sink from the outlet connected on the heatsink fan and the system board [2].
NOTE:
The thermal pad attached to the heatsink stick to the fan and SSD. Applying strong force can bend the
heatsink while lifting the heatsink from the system.
34
Extracción e instalación de componentes
After working inside your
Before working inside your
computer.
computer.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7212T03h

Tabla de contenido