Beninca DA.24SL Libro De Instrucciones página 16

A
Stop.
Cams.
The barrier starts from the point "A" and arrives to the interventation of the stops in closing phase with
a speed selected through the cycle speed trimmer which is set on the central unit board.
the braking cycle begins from the intervention of the stop. The barrier goes to through the braking
space about 6s at a speed which can be adjusted by the means of the braking speed trimmer on the
central unit board. The barrier arrives to the point "B" thus completing the closing moviment.
Ibid as regards the aperture cyrcle.
Then regulate stops, cams, and the trimmers of the central unit board keeping these consideretions in
mind.
N.B. The regulation of the couple regulation trimmer of the central unit board depends on the regulation
made on the cyrcle speed trimmer and on the braking speed trimmer; after each variation on the cycle
speed or on the braking speed you should regulate the couple regulation trimmer again.
16
Movements and working times of a barrier
Intervention point of
the mechanical stop
in aperture.
Working cycle of the barrier.
Photo-devices
Move the cams or the stops to have the working cycle
you want the barrier to do.
Connect the stops to the correspondent clamps of the
central unit.
Intervention point of
the mechanical stop
in closing.
Locating of cams and stops
B