Pride Mid-size Serie Manual Del Usuario página 13

Manual Freewheel Lever
Whenever you need or want to push your scooter
for short distances, you can put it in freewheel
mode.
1. Remove the key from the key switch.
2. Push forward on the manual freewheel lever to
disable the drive system and the brake system.
This will enable you to push the scooter.
NOTE: If your scooter is equipped with a 2-
position manual freewheel lever, you must pull up
on the lever and then push forward on the manual
freewheel lever to disable the drive system and the
brake system. This will enable you to push the
scooter.
3. Pull back on the manual freewheel lever to
reengage the drive and the brake systems and
take your scooter out of freewheel mode.
WARNING! When your scooter is in
freewheel
system is disengaged.
Disengage the drive motors only
on a level surface.
Ensure the key is removed from
the key switch.
Stand to the side of the scooter
to engage or disengage free-
wheel mode. Never sit on a
scooter to do this.
After you have finished pushing
your scooter, always return it to
the drive mode to lock the
brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in
the "on" position, the scooter will not run until the manual freewheel lever is pushed rearward and the
key is turned to the "off" position, then back to the "on" position.
Motor/Transaxle Assembly
The motor/transaxle assembly is an electromechanical unit that converts electrical energy from your
scooter's batteries into the controlled mechanical energy that drives the scooter's wheels.
Mid-size Scooter Series
I I . Y O U R S C O O T E R
mode, the braking
IDENTIFICATION KEY
1. MANUAL FREEWHEEL LEVER
2. MOTOR/TRANSAXLE ASSEMBLY
3. ANTI-TIP WHEELS
4. SAFETY FLAG BRACKET
2
4
Figure 5. Rear Components
1
3
13