Pride Mid-size Serie Manual Del Usuario página 21

I I I . B A T T E R I E S A N D C H A R G I N G
You may need the following to change your batteries:
Metric/standard socket set and ratchet
Adjustable wrench
WARNING! Do not lift beyond your physical capability. Ask for assistance when
necessary while disassembling or assembling your scooter.
WARNING! Do not pull on electrical harness wires directly to detach them from the
scooter. Always grasp the connector itself when disconnecting the harness to prevent
wire damage.
To change batteries in your scooter:
1. Remove the seat and battery shroud. See figure 10.
2. Disconnect the battery tie-down strap. See
figure 11.
3. Disconnect the battery harnesses by depressing the
tabs on the battery harness connectors and pulling
them straight up. See figure 11.
4. Disconnect the battery cables from the battery
terminals by sliding back the terminal boots and
unscrewing the nut from the bolt. See figure 12.
5. Remove the old batteries from the battery wells.
6. Place a new battery in each battery well. Face the
battery terminals of each battery opposite each
other and toward the outer sides of the scooter. See
figure 11.
7. Connect the red battery cable to the positive (+)
battery terminal on each battery.
8. Connect the black battery cable to the negative (-)
battery terminal on each battery.
9. Reposition the terminal boots over the battery
terminals.
10. Reconnect the battery harnesses.
11. Reconnect the battery tie-down strap.
12. Reinstall the battery shroud and seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact
your local waste disposal agency or your authorized dealer for instructions on disposal and battery
recycling, which is our recommended course of action.
Mid-size Scooter Series
1
Figure 10. Battery Shroud Removal/Installation
1
2
*MODEL 104 ONLY
21