LG LSD4913 Serie El Manual Del Propietario página 58

58 TROUBLESHOOTING
Symptoms
The oven door does
not open after a Self
Clean cycle.
The oven door is
not clean after a Self
Clean cycle.
Clean and door flash
in the display
"Loc" message
appears when you
want to cook.
Oven control beeps
and displays an F
error code.
The oven racks were
cleaned in a Self
Clean cycle.
Clock is flashing.
"Burning" or "oily"
odor emitting from the
vent.
Strong odor.
Fan noise
Fan operation
Burners are not
lighting properly after
cleaning the cooktop
surface.
When lighting just one
burner, clicking noise
is heard from all the
burners.
Light can be seen
through the oven air
vents.
Possible Cause / Solutions
The oven temperature is too high. Wait up to one hour for it to cool down.
• Incorrect oven control settings. See Self Clean in the MAINTENANCE section.
• The oven was heavily soiled. Clean up heavy spills before beginning the Self
Clean cycle. Heavily soiled ovens may need either a longer Self Clean or two
Self Clean cycles.
• The self clean cycle has been selected, but the door is not closed.
- Close the oven door.
The oven door is locked because the temperature inside of the oven is too high.
Press and hold Clock for three seconds.
• Check the main gas shut-off valve or
the oven gas shut-off valve and call
for service.
• Remove the power from the range
for five minutes and then reconnect
the power. If the function error code
repeats, call for service.
Apply a small amount of vegetable oil to a paper towel and wipe the edges of the
oven racks. Do not use lubricant sprays.
Power outage or surge. Reset the clock. If the oven was in use, you must reset
it by pressing the oven mode knob to the Off position. Reset the clock and any
cooking function.
This is normal in a new oven and will disappear with use. To speed the process,
set a Self Clean cycle for a minimum of three hours. See Self Clean in the
MAINTENANCE section.
An odor from the insulation around the inside of the oven is normal for the first few
times the oven is used.
• A convection fan may automatically turn on and off.
- This is normal.
It is normal for the fan to operate periodically throughout a normal bake cycle in the
oven. This is to ensure even baking results.
Make sure that the burner heads and caps are completely dry and properly
positioned.
This is normal. Electric spark igniters from the burners cause the clicking noise. All
the spark igniters on the cooktop will activate when igniting just one burner.
While the Broil function is running, it is normal to see a light between the oven air
vents.
CODE CAUSE
F-3 Key short error
F-9 Oven not heating