Installation Steps; Care And Cleaning - AVS Bugflector Instrucciones De Instalación

Installation Steps

Remove hood shield from hood. Remove the corresponding factory installed rubber seal retaining fasteners that were marked in Step 2.
NOTE: Some applications may require additional fasteners to be removed in order to fully access the holes underneath.
3
Center hood shield on hood, and slide hood shield flanges UNDER
the rubber seal. Align hood shield flanges with holes in hood.
4
Close hood. Adjust hood bump stops to raise hood as needed.
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade™, the Auto Ventshade™ logo and the AVS™ logo are trademarks of Lund, Inc.
™
NOTE: Actual application may vary slightly from illustrations.
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2018 Lund, Inc. All rights reserved.
NOTE: Exercise extreme caution not to tear
or damage the rubber seal when seperating
from hood.
Install a fastener at each flange location.
5
Install bump ons at pre-cleaned locations on the
7
The material that your product is made from can
be recycled. Please also consider recycling the
Page 2 of 2
Hood
Hood Shield
Rubber Seal
Fastener
Do not overtighten
painted hood surface.
packaging that your product came in.
X6