Fossil TY2723 Manual Del Usuario página 10

Digital MLL-020
Normal Time Display
1 . Press A to change to chronograph mode .
2 . Press B for EL .
3 . Press and hold C to display date .
4 . Press and hold C and then push D to toggle month/date format .
5 . Press and hold D to display alarm time .
6 . Press and hold D and then push A to toggle 12/24-hour format .
NOTE: At any point in any setting mode, press A to exit setting mode.
Time and Calendar Setting
1 . In normal time display, press and hold A for 3 seconds, then press A again; Tuesday flag and seconds
digits will begin flashing .
2 . Press D to set seconds to zero .
3 . Press C to advance to minute .
4 . Press D to advance digit, press and hold D for fast advance .
5 . Press C to advance to next setting value .
6 . Setting sequence is: seconds, minute, hour, month, date, weekday .
7 . Press A to exit setting mode .
Alarm Mode
1 . In normal time display, press and hold D and then push C to toggle alarm/chime on/off .
2 . Alarm will sound at preset time for 30 seconds; press D to silence alarm .
3 . To test alarm, press and hold C and D simultaneously . Alarm will beep .
Alarm Setting
1 . In normal time display, press and hold A for 3 seconds; Monday flag and hour will begin flashing .
2 . Press D to advance digit; press and hold D for fast advance .
3 . Press C to set and advance to minute .
4 . Press D to advance digit; press and hold D for fast advance .
5 . Press A to exit setting mode .
Chronograph Mode
1 . Press A to change to chronograph mode .
2 . Press C to start/stop the chronograph .
3 . Press D to reset to zero .
16
B C
D
A
Split Time
1 . Press D while the chronograph is running for split time .
2 . Press D again to return to chronograph .
3 . Repeat steps 1 & 2 to measure multiple split times .
4 . Press C to finalize timing .
5 . Press D to reset to zero .
Digital MLL-004
Normal Time Display
1 . Press A to display month/date for 3 seconds .
2 . Press A twice (or once if date is displayed) to display seconds . Press A again to return to Normal Time
Display .
Time And Date Setting
1 . From Normal Time Display, press B twice to enter setting mode; month will be displayed .
2 . Press A to increase value .
3 . Press B to set and advance to next setting .
4 . Setting sequence is: month, date, hour, minute .
5 . Press B to exit setting mode; press A to activate watch .
NOTE: Colon will flash between hour and minutes in Normal Time Display to indicate watch is active.
A
B
17